If you are building a new home in Yuma, the window for running network, control, audio and security wiring is shorter than most homeowners think. Once insulation and drywall go in, adding a cable run means cutting into a finished wall, patching, and repainting. Before that happens, the framing is open and every wire you might want later can be run once, cleanly, for far less trouble than retrofitting it.
Why the Pre-Drywall Window Matters
Framing exposes every stud bay in the house. That is the only point where a low-voltage crew can run cable in a straight path to exactly where it needs to go, without routing around finished surfaces or fishing wire through closed walls. WOW Electronics coordinates this work with your builder's own framing schedule, so the pre-wire pass happens inside the rough-in window and clears out before insulation starts — it does not hold up the next trade.
Deciding what to wire now does not mean deciding what equipment to buy now. Pre-wire is about getting the right cable to the right locations; the touchscreen, camera or speaker that eventually connects to it can be chosen later, even years later, without opening the wall again.
Lighting deserves the same early planning. Keypad locations, fixture layouts and lighting-control wiring are covered in our guide to custom home lighting and prewiring before drywall.
Networking, Control, Audio and Security Wiring to Run Now
Structured, low-voltage pre-wire is really one pass that covers several needs at once: data, audio, control and security wiring, home-run and labeled back to a central location rather than scattered connections. For a typical new Yuma home, that pass should plan for:
